Sensitive chemically amplified electrochemical detection of ruthenium tris-(2,2′-bipyridine) on tin-doped indium oxide electrode

Optimized combination of chemical agents was selected for sensitive electrochemical detection of dissolved ruthenium tris-(2,2′-bipyridine) (Ru-bipy). The detection was based on the chemical amplification mechanism, in which the anodic current of a redox-active analyte was amplified by a sacrificial electron donor in solution. On indium-doped tin oxide (ITO) electrodes, electrochemical reaction of the analyte was reversible, but that of the electron donor was greatly suppressed. Several transition metal complexes, such as ferrocene and tris-(2,2′-bipyridine) complexes of osmium, iron and ruthenium, were evaluated as model analyte. A correlation between the amplified current and the standard potential of the complex was observed, and Ru-bipy generated the largest current. A variety of organic bases, acids and zwitterions were assessed as potential electron donor. Sodium oxalate was found to produce the largest amplification factor. With Ru-bipy as the model analyte and oxalate as the electron donor, the analyte concentration curve was linear up to 50 μM, with a lower detection limit of approximately 50 nM. Preliminary work was presented in which a Ru-bipy derivative was attached to bovine serum albumin and detected electrochemically. Although the combination of Ru-bipy, oxalate and ITO electrode has been used before for electrochemiluminescent detection of Ru-bipy and oxalate, as well as electrochemical detection of oxalate, its utility in amplified voltammetric detection of Ru-bipy as a potential electrochemical label has not been reported previously.     

High-Power CO2 Laser System with Repetition Rate Operation for High Current Multicharged Heavy Ion Generations

Experimental and numerical calculation results devoted to development of an optical system for an ion source based on a repetition rate CO₂ laser are described. The laser chain consists of a master oscillator, gas absorber cells, and a four-pass amplifier. The optical system provides smooth laser pulses with variable duration and high spatial quality that ensures efficiency for plasma heating and ion generation. The parameters of the plasma ion component measured in the CERN laboratory are applied for a lead target illumination.     

高功率LDA紧密侧面抽运Nd:YLF两级双程离轴放大系统实验研究

 介绍了一台10mm口径两级双程离轴放大系统，实现了对5mm×5mm口径光束的激光放大，耦合系统采用高功率LDA紧密侧面直接抽运棒状Nd:YLF方式。分析并实验研究了在不同抽运电流、放大脉冲与放大器LDA抽运时刻的不同延时及不同注入能量条件下，放大系统及光束每次放大时放大特性的规律。实验得到：在放大系统5mm×5mm软光阑处注入1.58mJ能量时，放大系统可输出129.2mJ能量，能量提取效率达到19.5%，满足该系统的设计指标。     

光参量啁啾脉冲饱和放大的增益稳定性

 光参量啁啾脉冲放大（OPCPA）在饱和放大区存在一个增益稳定点，据此设计了一个输出稳定的三级OPCPA系统；第一、二、三级分别选用准相位匹配的周期极化钛氧磷酸钾（PPKTP）晶体、LBO晶体和KDP晶体作为增益介质。饱和放大时，增益随泵浦光强度变化时的增益输出稳定性明显改善，在泵浦光强度抖动低于6%的情况下，各级光参量放大器OPA输出的增益抖动小于1%。前级采用准相位匹配的PPKTP晶体作为增益介质，在远低于破坏阈值的30MW/cm²的泵浦功率密度下，可得到2×10⁵的饱和放大增益和20%的能量转换效率。     

高功率飞秒脉冲激光器的进展

概述了超短激光脉冲技术发展的历程。详尽的论述了啁啾脉冲放大技术的原理和一些关键技术 ,并对当今飞秒激光器研究发展的状况进行了综述。在分析其应用前景的基础上 ,进一步指出了这一技术领域未来的发展趋势。结果表明 ,脉冲激光放大系统以后的发展方向是 :更短脉冲 ;追求更高峰值功率 ;连续光谱调谐化 ;向小型化乃至全光纤化发展。     

Phase and Amplitude Characteristics of Injection Lasers with Allowance for the Effects of Nonlinear Amplification in Current Modulation

The influence of the parameter of amplitude-phase coupling for nonlinear amplification on the phase-frequency characteristics of an injection laser in the regime of pumping current modulation has been investigated theoretically. The parameter is defined as the coefficient of proportionality between changes in the real and imaginary parts of the refractive index during variation of the density of photons in the cavity. The substantial dependence of the coefficient of phase modulation on the parameter of the amplitude-phase coupling for nonlinear amplification at small modulation frequencies is shown. A technique to determine the indicated parameter based on the frequency dependence of the ratio between the coefficients of phase and amplitude modulation is suggested.     

光参量啁啾脉冲放大增益特性研究

 通过对非线性三波耦合方程组进行数值求解，研究了光参量放大的增益特性及饱和放大特性。给出了泵浦光、信号光参数对参量增益的影响及其与晶体饱和长度的关系。且OPA具有传统CPA系统所不具有的优点，将有可能取代传统的CPA系统而作为超短超强激光系统的新型前端。     

基于SOA和NOLM的光脉冲放大与压缩的设计模型

设计了一种基于半导体光放大器(SOA)和非线性光学环镜(NOLM)的光脉冲放大与压缩的模型。数值研究结果表明:在NOLM中,当调节合适的控制脉冲的输入和初始时延时,具有较低峰值功率、宽度为几十皮秒的高斯信号脉冲经此模型放大压缩后,可以得到脉冲峰值增益高、脉冲宽度窄以及基本无基座的高质量超短信号光脉冲。     

Calculation of heat transfer and uniformity of chemical amplification during post-exposure bake

Heat transfer in a resist-coated silicon wafer using a bake process is theoretically evaluated by modeling the three-dimensional diffusion process, focusing on the controllability of the lithographic performance of chemically amplified resists. Six models of various ambient conditions are used. The proximity gap between the hotplate and the wafer is found to have a dominant influence on the heat transfer process for the whole system. Because the atmosphere near the wafer acts as a thermal diffusion buffer layer, no temperature gradient occurs in the resist, even when it is subjected to convective heat transfer from the resist surface. Experimental results obtained by X-ray lithography confirm the calculation results.     

孤子掺杂光纤放大的半径典模型与分析

建立了孤子掺杂光纤放大的半经典模型，给出了分布放大透明传输的泵浦条件，详细讨论了激发态吸收的影响．文中结果为Ｅｒ￣３＋掺杂光纤孤子放大器的设计提供了重要理论依据．